12
Function Description
Local Listen Port Number:
If the device is using the TCP/IP protocol to drive the data transfer via remote instructions, the
Serial Server Mode must be set to TCP SERVER and the LISTEN PORT NUMBER configuration
and monitoring side must be the same value, the default is 50001
Close Connection When Remote Idle:
1. Set the idle disconnection time, the default value is 0 seconds, the range is 0 ~ 32768
2. When you want to keep the BF-1010 connected to the monitoring at all times, you must set this
value to 0, otherwise the segment connection will be automatically cut when no data is transmitted
on the line beyond the set time
Max Connection:
Set the maximum number of TCP connections, the maximum can be set to 3 TCP connections, the
default value is 3
Access Password:
To ensure the security of datas, the user can set a password to enter and control. When the datas are
transferred, the correct password must be entered to obtain permission before proceeding to the next
steps. Enter up to 31 characters.
Keep Alive Check:
When connected, a ping packet is sent to the Gateway Router to ensure the connection every 30
seconds.
To Next Page
Loading...
Need help?
General