Chroma 6460 - Page 59

Remote Operation
5-11
This command sets delay time when software protection occurs. The time unit is 0.1
second.
RANGe HIGH | LOW Set output voltage range
This command sets the output voltage range of the AC source.
HIGH sets the AC source at 300V (high) range.
LOW sets the AC source at 150V (low) range.
[SOURce :]
CURRent
:LIMit
[: AMPLitude] < NR2>
[SOURce :] CURRent : LIMit [ : AMPLitude] <NR2>
Query syntax [SOURce :] CURRent : LIMit [ : AMPLitude]?
Parameter 0.0 to 100.0
Return parameters <NR2>
This command sets the voltage limit of the AC source. The unit is 0.1 ampere.
[SOURce :]
VOLTage
[ : LEVel]
[ : IMMediate]
[ : AMPLitude] <n> Set the rms voltage amplitude
[SOURce :] VOLTage [ : LEVel] [ : IMMediate] [ : AMPLitude] <NR2>
Query syntax VOLTage [ : LEVel] [ : IMMediate] [ : AMPLitude]?
Return parameters <NR2>
This command sets the rms output voltage level of the AC source.
[SOURce :] VOLTage : LIMit : AC <NR2>
Query syntax [SOURce :] VOLTage : LIMit : AC?
Parameter 0.0 to 300.0
Return parameters <NR2>
This command sets the voltage limit of the AC source. The unit is 0.1 volt.
SYSTem
: ERRor? Query the error string
Response error string :
No Error Data Format Error Data Range Error
Too Many Errors Execution Error
TRACe | DATA
[ : DATA] <US1, . . , US6>, <D1, D2. . .> Assign value to a waveform
SYSTem : LOCal