21
6. Check Control Messages
1. Messages in explicit mode 5
new cycle and then appear again if the cause that generated them returns
2. Messages in codeExxx
· E
· xxx
Messages in explicit mode
MESSAGE
Machine cold
No coffee
Grounds
drawer full
Empy drawer
Grounds
drawer
removed
Boiler lling
Service
needed
No milk
VERIFICATIONS
2. Consult the technical manual and refer to the
display to solve the problem
until when the machine will display the mes-
Consult the technical manual to program the
number of grounds to the attainment of which
-
-
-
This operation is performed automatically
This operation does not impede the hot water
The message will be displayed until the serv-
-
POSSIBLE CAUSES: when the message is visualized
1. This message will appear on the display every time the ma-
chine is turned on until the service boiler pressure falls below the
2. -
the message in code identifying the component that caused
The machine counts in decreasing order the pre-set maximum
The machine is blocked and no coffees beverages can be de-
This message always appears when the back side of the
boiler
This message is displayed when the machine requires the peri-
The message will reappears in the successive relighting of the
The message is displayed only if the machine is connected to
-
To Next Page
Loading...
