Cimbali S39 - Customer Programming; Clock Adjustment

23
1. Clock adjustment
Use the “+” (30) and “-” (31) keys to adjust the clock.
The time increases (or decreases) one minute each time the
key is pressed.
If one of the keys (30 or 31) is pressed and held down for more
than 10 seconds, the minutes setting stops and the hours
setting increases (or decreases).
During the time setting phase, the seconds remain at "00".
15 April 2009
wednesday 15:15:04
2. Meter display and reset
Press key “i” (27) to display the meters.
The following message will appear on the display (5):
To access the various menus, position the cursor on the line
that interests you, using the “+” (30) or “-” (31) keys.
3. How to access the programming mode
Use the “+” (30) and “-“ (31) keys also to modify the message
or number.
Note: When modifying data, the cursor changes to "".
Exiting the programming menu
Machines WITH the OK key
there are two possibilities:
1) Press the OK key to conrm changes
2) Press the RES (24) key to leave settings unchanged and
exit the menu
If the "Customer Progr." is set to "NO", the following message
will appear on the display:
N.B. ONLY if the item “Customer Progr.” is set on “YES" and
the item “Program. block” is set on “NO".
To access programming press the PRG (29) key; the following
message will appear on the display:
Access to menus: press a selection key.
Access and modication of sub-menus: Use the “+” (30) and
“-“ (31) keys to position the cursor (black line) on the desired
line, then press the PRG (29) key.

CUSTOMER PROG.
NOT ENABLED!

 CUSTOMER PROG.
KEY MENU
Press the PRG (29) key and then press the "+" (30) and "-"
(31) keys to reset the number. The meter will be reset.
The total number of coffees and the number of cycles cannot
be zeroed.
The total number of grinding procedures recorded for the two
grinders (MM1 and MM2) can only be zeroed by the installer
technician when the grinders are replaced.
At this point, depending on the machine model:
- press the RES (24) key to conrm and return to the previous
menu;
or
- press the “OK” key to conrm and the RES (24) key to return
to the previous menu.
+


KEY MENU
Type 1 coffee
repetition 001
Water dose 110
MM1 cof, dose 043
MM2 cof, dose 000
+


COUNTERS MENU
N° coffee 25
N° milk 15
N° water 10
N° steam 5
N° steam+air 9
CUSTOMER PROGRAMMING