Cisco 3110 Hardware Installation Guide

Figure 46: Remove the Network Module
Captive screw2Ejector handle1
If the slot is to remain empty, install a blank faceplate to ensure proper airflow and to keep dust out of the chassis;
otherwise, install another network module.
Step 4 To replace a network module, hold the network module in front of the network module slot on the right of the chassis,
press the ejector handle, and pull out the handle.
Step 5 Slide the network module into the slot, push it firmly into place, and close the handle on the front of the network module.
Step 6 Tighten the captive screw on the upper left side of the network module.
Step 7 Power on the chassis so that the new network module is recognized.
Remove and Replace the SSD
The chassis supports two NVMe SSDs. The first SSD slot (SSD-1) is for storage. The second slot (SSD-2) is
for the optional SW RAID1 support only. See SSDs, on page 27 for more information.
Cisco Secure Firewall 3110, 3120, 3130, and 3140 Hardware Installation Guide
67
Installation, Maintenance, and Upgrade
Remove and Replace the SSD

Cisco 3110 Specifications

General

Brand	Cisco
Model	3110
Category	Firewall
Language	English