Cisco 3110 Hardware Installation Guide

Figure 47: Remove the SSD
SSD release tabEjector handle1
Step 5 To replace the SSD in slot 1, make sure the power switch is still in the OFF position (if you are replacing SSD-1), and
then hold the SSD with the ejector handle extended in front of slot 1, push it in gently until it is seated, and close the
ejector handle.
Step 6 You can install the RAID1 SSD in slot 2. Make sure the power switch is still in the OFF position, and then remove the
blank faceplate in slot 2 by loosening the handle on the faceplate.
Step 7 Hold the RAID1 SSD with the ejector handle extended in front of slot 2, push it in gently until it is seated, and close the
ejector handle.
Do not switch the two SSDs. The RAID1 SSD must be installed in slot 2.
Caution
Step 8 Check the SSD LED to make sure the SSD is operative. See Front Panel LEDs, on page 11 for a description of the SSD
LEDs.
Step 9 Add SSD-2 to the RAID configuration using the raid add local-disk 1|2 command.
Cisco Secure Firewall 3110, 3120, 3130, and 3140 Hardware Installation Guide
69
Installation, Maintenance, and Upgrade
Remove and Replace the SSD

Cisco 3110 Specifications

General

Brand	Cisco
Model	3110
Category	Firewall
Language	English