Cisco 3110 Hardware Installation Guide

Safety Warnings
Take note of the following warnings:
Statement 1002—DC Power Supply
When stranded wiring is required, use approved wiring terminations such as closed-loop or spade-type
with upturned lugs. These terminations should be the appropriate size for the wires and should clamp
both the insulation and conductor.
Warning
Statement 1003—DC Power Disconnection
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1015—Battery Handling
To reduce risk of fire, explosion or leakage of flammable liquid or gas:
• Replace the battery only with the same or equivalent type recommended by the manufacturer.
• Do not dismantle, crush, puncture, use sharp tool to remove, short external contacts, or dispose of
in fire.
• Do not use if battery is warped or swollen.
• Do not store or use battery in a temperature > 60° C.
• Do not store or use battery in low air pressure environment < 69.7 kPa.
Warning
Statement 1022—Disconnect Device
To reduce risk of electric shock and fire, a readily accessible two-poled disconnect device must be
incorporated in the fixed wiring.
Warning
Statement 1025—Use Copper Conductors Only
To reduce risk of fire, use copper conductors only.
Warning
Statement 1030—Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Cisco Secure Firewall 3110, 3120, 3130, and 3140 Hardware Installation Guide
72
Installation, Maintenance, and Upgrade
Remove and Replace the Power Supply Module

Cisco 3110 Specifications

General

Brand	Cisco
Model	3110
Category	Firewall
Language	English