Figure 55: Clamp on Over Mold of Power Cord
Power cord over mold
Clamp release tab
2Power cord1
Direction to squeeze the clamp ties4Tie clamp annular teeth3
—Clamp release tabs5
Step 4 If you need to remove the power cord, push the release tab on the clamp to force the annular clamp teeth to disengage
and the clamp opens up. You can then remove the clamp from the power cord.
Cisco Secure Firewall 3110, 3120, 3130, and 3140 Hardware Installation Guide
79
Installation, Maintenance, and Upgrade
Secure the Power Cord on the Power Supply Module
To Next Page
Loading...
