EasyManuals Logo

Cisco 3700 series User Manual

Cisco 3700 series
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
3-31
Cisco 3700 Series Routers Hardware Installation Guide
OL-2180-08
Chapter 3 Installing the Router
Configuring the Router
Note The interface numbering that appears is dependent on the type of Cisco modular router platform
and on the installed interface modules and cards.
Current interface summary
Controller Timeslots D-Channel Configurable modes Status
T1 0/0 24 23 pri/channelized Administratively up
Interface IP-Address OK? Method Status Prol
FastEthernet0/0 unassigned NO unset up up
FastEthernet0/1 unassigned NO unset up dow
Step 9 Choose one of the available interfaces for connecting the router to the management network:
Enter interface name used to connect to the
management network from the above interface summary: fastethernet0/0
Step 10 Respond to the following prompts as appropriate for your network:
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: no
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 16 subnet bits; mask is /16
The configuration is displayed:
The following configuration command script was created:
hostname fig
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
media-type 100BaseX
half-duplex
ip address 172.1.2.3 255.255.0.0
!
interface FastEthernet0/1
shutdown
no ip address
!
end
Step 11 Respond to the following prompts. Choose [2] to save the initial configuration.:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.

Table of Contents

Other manuals for Cisco 3700 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3700 series and is the answer not in the manual?

Cisco 3700 series Specifications

General IconGeneral
Connectivity TechnologyWired
Operating SystemCisco IOS
Operating Temperature32 to 104°F (0 to 40°C)
Storage Temperature-4 to 149°F (-20 to 65°C)
Routing ProtocolsBGP, OSPF, EIGRP, RIP, IS-IS
Network ManagementSNMP, CiscoWorks
Security FeaturesACLs, VPN, Firewall, RADIUS, TACACS+
Product TypeNetwork Router
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet, Serial, Frame Relay, ATM
Network/Transport ProtocolTCP/IP, UDP
Remote Management ProtocolSNMP, Telnet, SSH
FeaturesQuality of Service (QoS)
WAN InterfacesSerial, ISDN, Frame Relay, ATM
LAN InterfacesEthernet, Fast Ethernet, Gigabit Ethernet
ProcessorMotorola PowerPC
InterfacesVariety of modular interface cards including Ethernet, Fast Ethernet, Gigabit Ethernet, Serial, ISDN, ATM, and Voice/WAN Interface Cards (VICs/VWICs)

Related product manuals