To Next Page

To Previous Page

How you configure your 3G MicroCell is dependent on what equipment you currently use to connect to the Internet.

• If you have either a gateway or modem and Wi-Fi router, follow OPTION A on page 9.

• If you only have a modem attached directly to your computer, follow OPTION B on page 10.

• If you have a modem, and a Wi-Fi router and want to prioritize your 3G MicroCell connection because other Internet

use impacts the 3G MicroCell’s performance, follow our Priority Mode Configuration which is OPTION C on page 11.

If you haven’t already activated your 3G MicroCell when you purchased it, you must

do so now.

1. Launch your web browser and visit:

att.com/3GMicroCell.

2. Locate the Activate my AT&T 3G MicroCell

area on the lower portion of the

home page and click on the applicable link.

3. When prompted, enter your AT&T Online Wireless Account user name and

password. If you don’t have one, follow the on-screen instructions to create one.

4. Follow the remaining on-screen steps until you reach the confirmation screen.

Note: As an added benefit, when placing a 911 call while connected to your 3G

MicroCell, the full location address you provide in your online activation will be sent to

local emergency responders. A built-in Global Positioning System (GPS) feature helps

deliver this functionality.

Step 2: Configuration and Powering Up

• Place your MicroCell within 3 feet of a window, if possible.

• Make sure your MicroCell is at least 1 foot away from your gateway or modem and Wi-Fi router.

• Refer to FAQ 1.3 on page 16 for additional details on product placement.

Step 1: Online Activation

Write down your 3G MicroCell’s

serial number as you will need

it for online activation and for

future reference.

Serial # (S/N): -

Connect Your Devices with USB Cables?

If you currently use a USB cable to connect your modem and computer you will no longer be able to do so.

You have 2 cabling alternatives:

Alternative A: Remove the USB cable and install Ethernet cables according to Option A, B, or C as described above.

Note: This option requires a second Ethernet cable which is not included in your AT&T 3G MicroCell™ box.

Alternative B: Obtain USB-to-RJ45 adapters (not shown) and install one with the yellow Ethernet cable and the other with

your USB cable and then select from Option A, B, or C as described above.

Cisco 3G MicroCell User Manual

Other manuals for Cisco 3G MicroCell