Cisco 500 Series User Manual

14 500 Series Stackable Managed Switches
• Ports XG1 and XG2 are available as standard network ports
–Speed—1G or 10G
Stacking Option Two:
• Ports XG3/S1 and XG4/S2 are not available
• Port S1, S2 and 5G are configured as stack ports
–Speed—1G, 5G, 1G/5G-auto
• Ports XG1 and XG2 are available as standard network ports
–Speed—1G or 10G
Non-Stacking standalone option:
• Ports XG3/S1 and XG4/S2 available as standard network ports
–Speed—1G or 10G
• Port S1, S2 and 5G are not available
• Ports XG1 and XG2 are available as standard network ports
–Speed—1G or 10G
For the SF500-24, SF500-24P, SF500-24MP, SF500-48, SF500-48P,
SF500-48MP, SG500-28, SG500-28P, SG500-28MPP, SG500-52, SG500-
52P, and SG500-52MP devices, the following information applies:
Stacking Option One (default option):
• Ports S3 and S4 are configured as stack ports
–Speed—1G, 5G, 1G/5G-auto
• Ports S1 and S2 are available as standard network ports
– Speed—1G or 100M
• Port S1/SFP, S2/SFP are available as standard network ports
– Speed—1G or 100M
NOTE These two connection options (S1 and S2 or S1/SFP and S2/SFP)
cannot run at the same time, they are configured as one or the other. Any
connections using the SFP ports take precedence over the other
combination ports.
Stacking Option Two:
• Ports S1/SFP and S2/SFP are configured as stack ports
–Speed—1G

Cisco 500 Series Specifications

General

Model	Cisco 500 Series
Category	Switch
Mounting	Rack-mountable
Management	Web-based, CLI, SNMP
Ports	24, 48
Port Speed	10/100/1000 Mbps
PoE Support	Available on some models
Switching Capacity	Up to 176 Gbps
MAC Address Table Size	16, 000 entries
Security	ACLs, 802.1X
Quality of Service (QoS)	Yes
Dimensions	Varies by model
Weight	Varies by model
Humidity	10% to 90% non-condensing
Power Supply	Internal
Power Consumption	Varies by model
Jumbo Frame Support	Up to 9216 bytes