22 OL-24581-01
Set Up a Conference
(Cisco Unified IP Phone 6911 only)
1. Verify that you are on an active call (not on hold).
2. Press the Conference button .
3. Enter the phone number for the party you want to add to the conference.
4. Wait for the party to answer (or skip to Step 5 while the call is ringing).
5. Press the Conference button again.
The conference begins.
Repeat these steps to add more parties, if desired.
Hookflash
Hookflash allows you to activate features on your phone. To use hookflash, quickly press and release
the hookswitch button on the phone cradle rest.
Use Hookflash to Activate Features
(Cisco Unified IP Phone 6901 only)
You can use hookflash to:
• Answer a call
• Transfer between two calls (when one call is incoming only)
• Initiate a conference call
• Remove a conference participant
Hold
Hold allows you to put an active call into a held state.
Hold and Resume a Call
1. To put a call on hold, press the Hold button .
The Line button flashes green. The party that is put on hold hears the preset music.
2. To resume the call, press the flashing green Line button, press the Speaker button (Cisco Unified
IP Phone 6911 only), or go off hook, if the handset is in the cradle.
To Next Page
Loading...
