CHAPTER
5-1
Cisco 7206 Installation and Configuration Guide
OL-5102-02
5
Maintaining the Cisco 7206
This chapter describes basic maintenance procedures for the Cisco 7206. The procedures are presented
in the following sections:
• Viewing Your System Configuration, page 5-1
• Replacing a Port Adapter or Service Adapter, page 5-4
• Installing and Removing a Flash Memory Card, page 5-7
• Formatting a New Flash Memory Card, page 5-9
• Copying a Bootable Image onto a Flash Memory Card, page 5-10
• Copying Bootable Images between Flash Memory Cards, page 5-11
• Reformatting a Flash Memory Card, page 5-12
• Replacing or Recovering a Lost Password, page 5-14
Note For procedures that explain the use of the Flash Disk, refer to the Using the Flash Disk document.
For procedures that explain how to replace main, Flash, and ROM monitor memory in Cisco 7200 series
routers, refer to the Memory Replacement Instructions for the Network Processing Engine or Network
Services Engine and Input/Output Controller document.
The preceding documents are available on Cisco.com.
Viewing Your System Configuration
You can use the show version and the show diag commands to view information specific to the hardware
configuration of your Cisco 7206.
Use the show version (or show hardware) command to display the system hardware (the network
processing engine and the number of interfaces installed), the software version, the names and sources
of configuration files, and the boot images.
The following example shows the output from the show version command:
Router> show version
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-J-M), Released Version 11.1(17)CA
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Sun 21-Apr-96 04:10 by
Image text-base: 0x60010890, data-base: 0x605F0000
To Next Page
Loading...
Need help?
General
