6-8
Cisco 7206 Installation and Configuration Guide
OL-5102-02
Chapter 6 Troubleshooting the Installation
Troubleshooting the Cooling Subsystem
The above message could also indicate a faulty component or temperature sensor. Before the system
shuts down, use the show environment or show environment table command to display the internal
chassis environment. (Refer to the ““Functional Overview”” section in Chapter 1, “Product
Overview”” for descriptions of the show environment and show environment table commands.)
If you experience trouble with the startup that is not resolved with these procedures, contact a service
representative for assistance and further instructions.
To Next Page
Loading...
