(DRAFT LABEL) ALPHA DRAFT - CISCO CONFIDENTIAL
B-7
Cisco 7206 Installation and Configuration Guide
OL-5102-02
Appendix B Configuration Register Information
Setting the Configuration Register While Running ROM Monitor
enable “ignore system config info”? y/n [n]: n
change console baud rate? y/n [n]: n
change the boot characteristics? y/n [n]:y
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2 - 15 = boot system
[0]: 2
Configuration Summary:
enabled are:
load rom after netboot fails
console baud: 9600
boot: image sepcified by the boot system commands or default to: cisco2-c7200
do you wish to change the configuration? y/n [n] n
You must reset or power cycle for new config to take effect
rommon 2 >
To Next Page
Loading...
