EasyManuals Logo
Home>Cisco>Network Router>7206 - VXR Router

Cisco 7206 - VXR Router Installation Guide

Cisco 7206 - VXR Router
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
1-23
Cisco 7206 Installation and Configuration Guide
OL-5102-02
Chapter 1 Product Overview
Field-Replaceable Units
The RJ-45 port is the default media type for the I/O controller that is equipped with an MII port and an
RJ-45 port. Use the media-type command to change the I/O controllers media type and the show
interfaces command to verify the change. The following example configures the MII port as the media
type for the I/O controller:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# int fastethernet 0/0
Router(config-if)# media-type mii
Router(config-if)# no shutdown
Router(config-if)# exit
Router(config)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed
state to up
%LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
Router# show interfaces fastethernet 0/0
FastEthernet0/0 is administratively up, line protocol is up
(display text omitted)
Encapsulation ARPA, loopback not set, keepalive not set, hdx, MII
(display text omitted)
Use the media-type 100X command to return the media type to the RJ-45 port.
The default transmission mode for the Fast Ethernet port on the I/O controller is half-duplex. Use the
full-duplex command to change the Fast Ethernet ports transmission mode and the show interfaces
command to verify the change as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# int fastethernet 0/0
Router(config-if)# full-duplex
Router(config-if)# no shutdown
Router(config-if)# exit
Router(config)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed
state to up
%LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
Router# show interfaces fastethernet 0/0
FastEthernet0/0 is administratively up, line protocol is up
(display text omitted)
Encapsulation ARPA, loopback not set, keepalive not set, fdx, 100BaseTX
(display text omitted)
Use the no full-duplex command to return the Fast Ethernet port on the I/O controller to half-duplex
transmission mode.

Table of Contents

Other manuals for Cisco 7206 - VXR Router

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7206 - VXR Router and is the answer not in the manual?

Cisco 7206 - VXR Router Specifications

General IconGeneral
BrandCisco
Model7206 - VXR Router
CategoryNetwork Router
LanguageEnglish

Related product manuals