109
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
Multi-Processor WAN Application Module (MWAM)
Content Services Gateway (CSG) Module
With Supervisor Engine 32 12.2(33)SRC
Note
•
WS-SVC-PSD-1 runs its own software—See this publication for more information:
• http://www.cisco.com/en/US/products/hw/switches/ps708/prod_release_note09186a00801aae09.html
• WS-SVC-PSD-1 maintains state when an NSF with SSO redundancy mode switchover occurs.
• Route Switch Processor 720 does not support WS-SVC-PSD-1.
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-SVC-MWAM-1
3.57 A@42 V Multi-Processor WAN Application Module
With Supervisor Engine 720 12.2(33)SRA
With Supervisor Engine 32 12.2(33)SRC
Note
•
Route Switch Processor 720 does not support WS-SVC-MWAM-1.
• WS-SVC-MWAM-1 runs its own software—See this publication for more information:
http://www.cisco.com/en/US/products/hw/routers/ps368/prod_release_note09186a008020d583.html
• WS-SVC-MWAM-1 maintains state when an NSF with SSO redundancy mode switchover occurs.
• You should not use WS-SVC-MWAM-1 for broadband termination.
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-SVC-CSG-1
3.00 A@42 V Content Services Gateway (CSG) Module
With Supervisor Engine 720 12.2(33)SRA
With Supervisor Engine 32 12.2(33)SRC
Explanation
•
WS-SVC-CSG-1 runs its own software—Refer to this publication for more information:
http://www.cisco.com/en/US/products/sw/wirelssw/ps779/index.html
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version