Cisco 7600 Series Hardware

29
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
Distributed Forwarding Card 3CXL
Distributed Forwarding Card 3C
10-Gigabit Ethernet Switching Modules
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-F6700-DFC3CXL
2.35 A@42 V Distributed Forwarding Card 3CXL (DFC3CXL) for use on CEF720 modules
Supported with Supervisor Engine 720 and Route
Switch Processor 720
12.2(33)SRB
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-F6700-DFC3C
1.65 A@42 V Distributed Forwarding Card 3C (DFC3C) for use on CEF720 modules
Supported with Supervisor Engine 720 and Route
Switch Processor 720
12.2(33)SRB
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-X6704-10GE
6.28 A@42 V 4-port 10-Gigabit Ethernet XENPAK
• CEF720 with WS-X6700-CFC (adds 0.75 A@42 V)
• dCEF720 with WS-F6700-DFC3BXL (adds 3.30 A@42 V)
• dCEF720 with WS-F6700-DFC3B (adds 3.00 A@42 V)
• Supports egress multicast replication
• QoS port architecture (Rx/Tx):
– With DFC3: 8q8t/1p7q8t
– With CFC: 1q8t/1p7q8t
• Number of ports: 4
Number of port groups: 4
Port ranges per port group: 1 port in each group
Supported with Supervisor Engine 720. 12.2(33)SRA
Supported with RSP 720-1GE 12.2(33)SRB
Supported with RSP720-10GE 12.2(33)SRC

Cisco 7600 Series Specifications

General

Category	Network Router
Port Density	Varies by module
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Redundancy	Power supplies
Power Supply	AC or DC, Redundant options available
Operating System	Cisco IOS XR
Management	CLI, SNMP
Form Factor	Modular
Dimensions	Varies by chassis model
Weight	Varies by chassis model and configuration
Chassis Slots	6, 9, or 13