Cisco 7600 Series - Distributed Forwarding Card 3 B

28
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
Distributed Forwarding Card 3B
• WS-F6700-DFC3B, page 28
• WS-F6K-DFC3B, page 28
WS-F6700-DFC3B
WS-F6K-DFC3B
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-F6700-DFC3B
3.00 A@42 V Distributed Forwarding Card 3B (DFC3B) for use on CEF720 modules
Supported only with Supervisor Engine 720 12.2(33)SRA
Note
• WS-F6700-DFC3B uses memory that is installed on the switching module.
• Refer to this publication for information about WS-F6700-DFC3B upgrades:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_15893.html
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-F6K-DFC3B
1.67 A@42 V Distributed Forwarding Card 3B (DFC3B) for use on dCEF256 and CEF256
modules
Supported only with Supervisor Engine 720 12.2(33)SRA
Note
• Refer to this publication for information about WS-F6K-DFC3B memory upgrades:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_12409.html
• Supervisor Engine 720 supports a WS-F6K-DFC3B on these WS-X6516-GBIC switching module hardware revisions:
– Lower than 5.0
– 5.5 and higher
• Supervisor Engine 720 does not support a DFC3 on WS-X6516-GBIC switching module hardware revisions 5.0 through
5.4. With a Supervisor Engine 720 and with a DFC3 installed, WS-X6516-GBIC switching module hardware revisions
5.0 through 5.4 do not power up.
• With a Supervisor Engine 720 but without a DFC3, WS-X6516-GBIC switching module hardware revisions 5.0 through
5.4 operate in bus mode.
• Refer to external field notice 24494 for more information about Supervisor Engine 720 and a DFC3 on WS-X6516-GBIC
switching modules:
http://www.cisco.com/en/US/ts/fn/200/fn24494.html