27
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
Distributed Forwarding Card 3BXL
• WS-F6700-DFC3BXL, page 27
• WS-F6K-DFC3BXL, page 27
WS-F6700-DFC3BXL
WS-F6K-DFC3BXL
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-F6700-DFC3BXL
3.30 A@42 V Distributed Forwarding Card 3BXL (DFC3BXL) for use on CEF720 modules
Supported only with Supervisor Engine 720 12.2(33)SRA
Note
• WS-F6700-DFC3BXL uses memory that is installed on the switching module.
• Refer to this publication for information about WS-F6700-DFC3BXL upgrades:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_15893.html
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
WS-F6K-DFC3BXL
1.47 A@42 V Distributed Forwarding Card 3BXL (DFC3BXL) for use on dCEF256 and CEF256
modules
Supported only with Supervisor Engine 720 12.2(33)SRA
Note
• Refer to this publication for information about WS-F6K-DFC3BXL memory upgrades:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_12409.html
• Supervisor Engine 720 supports a WS-F6K-DFC3BXL on these WS-X6516-GBIC switching module hardware revisions:
–
Lower than 5.0
–
5.5 and higher
• Supervisor Engine 720 does not support a DFC3 on WS-X6516-GBIC switching module hardware revisions 5.0 through
5.4. With a Supervisor Engine 720 and with a DFC3 installed, WS-X6516-GBIC switching module hardware revisions
5.0 through 5.4 do not power up.
• With a Supervisor Engine 720 but without a DFC3, WS-X6516-GBIC switching module hardware revisions 5.0 through
5.4 operate in bus mode.
• Refer to external field notice 24494 for more information about Supervisor Engine 720 and a DFC3 on WS-X6516-GBIC
switching modules:
http://www.cisco.com/warp/public/770/fn24494.shtml
To Next Page
Loading...
Need help?
General
