30
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
Note
Note
•
WS-X6704-10GE requires one of the following:
–
WS-F6700-DFC3BXL (3.30A@42V)
–
WS-F6700-DFC3B (3.00 A@42 V)
–
WS-X6700-CFC (0.75 A@42 V)
• WS-X6704-10GE ships with WS-X6700-CFC installed unless ordered with WS-F6700-DFC3BXL or
WS-F6700-DFC3B.
• WS-X6704-10GE is supported in theWS-C6503-E chassis.
• WS-X6704-10GE is not supported in the WS-C6503 and CISCO7603 chassis.
• In a 13-slot chassis, WS-X6704-10GE is supported only in slots 9 through 13 and does not power up in other slots.
• On WS-X6704-10GE ports, Spanning Tree Protocol (STP) bridge protocol data units (BPDUs) are not exempt from Traffic
Storm Control suppression. Do not configure Traffic Storm Control on STP-protected WS-X6704-10GE ports that
interconnect network devices.
WS-X6502-10GE
3.30 A@42 V 1-port 10-Gigabit Ethernet
• With Supervisor Engine 720:
–
dCEF256 with WS-F6K-DFC3BXL (adds 1.47 A@42 V)
–
dCEF256 with WS-F6K-DFC3B (adds 1.67 A@42 V)
• QoS port architecture (Rx/Tx): 1p1q8t/1p2q1t
• Number of ports: 1
Number of port groups: 1
Port ranges per port group: 1 port in 1 group
With Supervisor Engine 720 12.2(33)SRA
With Supervisor Engine 32 12.2(33)SRA
Note WS-X6502-10GE does not support Inter-Switch Link (ISL) encapsulation.
Optical Interface Module (OIM) for WS-X6502-10GE
WS-G6488
10GBASE-LR serial 1310 nm long-reach OIM 12.2(33)SRA
WS-G6483
10GBASE-ER serial 1550 nm extended-reach OIM 12.2(33)SRA
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
To Next Page
Loading...
Need help?
General
