Cisco 7600 Series Hardware

16
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
Note
•
There are no memory-only upgrade options for RSP720-3C-GE.
• The following hardware and features are not supported by the RSP720-3C-GE:
– CISCO7603 router, OSR-7609 router (supported in SRA but not later releases).
– Optical Service Modules (OSMs), FlexWAN module (Enhanced FlexWAN module is
supported).
– In-service software upgrade (ISSU) is not supported in Cisco IOS Release 12.2SRB.
• The RSP720-3C-GE supports the SPA-IPSEC-2G beginning with Cisco IOS Release 12.2(33)SRC.
RSP720-3CXL-GE
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version
RSP720-3CXL-GE
7.33 A@42 V Route Switch Processor 720 with PFC3CXL:
• Two Gigabit Ethernet uplink ports: port 1 supports a 1-Gbps
small form pluggable (SFP) module; port 2 is configurable
with either a 1-Gbps SFP module or a 10/100/1000-Mbps
RJ-45
• Integrated 720-Gbps switch fabric
• PFC3CXL (high-capacity) and MSFC4 with 512-MB
bootflash, 4-MB NVRAM, 4-MB ROMMON, and several
DRAM options:
– Route processor (RP): 1- to 4-GB DRAM (default 2
GB)
– Switch processor (SP): 1- to 2-GB DRAM (default 1
GB)
• 2 CompactFlash Type II slots (on front panel) and 2-GB
internal CompactFlash (1 GB each for RP and SP)
• Requires larger power supplies and a high-speed fan tray
• QoS port architecture (Rx/Tx) is 1p1q4t/1p2q2t
12.2(33)SRB
Software Version SFPs Supported
12.2(33) SRE1, 15.0(1)S CWDM-SFP-1470=

Cisco 7600 Series Specifications

General

Category	Network Router
Port Density	Varies by module
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Redundancy	Power supplies
Power Supply	AC or DC, Redundant options available
Operating System	Cisco IOS XR
Management	CLI, SNMP
Form Factor	Modular
Dimensions	Varies by chassis model
Weight	Varies by chassis model and configuration
Chassis Slots	6, 9, or 13