EasyManua.ls Logo

Cisco 7600 Series - Overview: Cisco 7600 Series SIPs

Cisco 7600 Series
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
Note
Cisco IOS Release 12.2(33)SRE adds X2-DWDM and X2-10GB-LRM, X2 10GB-ZR support.
There are no memory-only upgrade options for the RSP720-3CXL-10GE.
The RSP720-3CXL-10GE does not support the following chassis and modules:
Unsupported chassis: Cisco 7603 and 7606.
Note Cisco 7613 rev 05 backplane support RSP720-3C-10GE and RSP720-3CXL-10GE from
12.2(33)SRE onwards.
Unsupported modules: Services modules (excluding the Network Analysis Module) , Optical
Service Modules (OSMs), FlexWAN module.
The RSP720-3CXL-10GE supports the following 10-Gigabit Ethernet optics: X2-10GB-LR,
X2-10GB-ER, X2-10GB-SR, X2-10GB-CX4, and X2-10GB-LX4.
The RSP720-3CXL-10GE supports the following Gigabit Ethernet optics: GLC-SX-MM,
GLC-LH-SM, GLC-ZX-SM, GLC-T, SFP-GE-S, SFP-GE-L, SSFP-GE-T, GLC-BX-D, and
GLC-BX-U.
In Cisco IOS Release 12.2(33)SRE, the RSP720-10GE adds support for the following features:
High-availability features such as NonStop Forwarding with Stateful Switchover (NSF/SSO) and
In-Service Software Upgrade (ISSU) are not supported.
The uplinks on the standby RSP720-10GE are active.
Broadband Aggregation features are supported.
In Cisco IOS Release 12.2SRC, the RSP720-3CXL-10GE does not support the following features, which
are supported on the RSP720:
High-availability features such as NonStop Forwarding with Stateful Switchover (NSF/SSO) and
In-Service Software Upgrade (ISSU) are not supported. Only Route Processor Redundancy (RPR)
mode is supported.
The uplinks on the standby RSP720-10GE are not active. This restriction exists because the uplink
ports must perform lookups on the active RSP, which is not possible in RPR mode.
Broadband aggregation features are not supported.
DWDM-SFP-5979
=
DWDM-SFP-6061=
DWDM-SFP-3346=
DWDM-SFP-3739=
DWDM-SFP-4134=
DWDM-SFP-4532=
DWDM-SFP-4931=
DWDM-SFP-5332=
DWDM-SFP-5736=
DWDM-SFP-6141=
Software Version SFPs Supported

Other manuals for Cisco 7600 Series

Related product manuals