Cisco 7600 Series - Page 39

39
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 15S
OL-10362-13
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
Supported Hardware
DWDM-SFP-4931= 12.2(33)SRE1
DWDM-SFP-5332= 12.2(33)SRE1
DWDM-SFP-5736= 12.2(33)SRE1
DWDM-SFP-6141= 12.2(33)SRE1
Note
• WS-X6724-SFP requires one of the following:
– WS-F6700-DFC3BXL (3.30 A@42 V)
– WS-F6700-DFC3B (3.00 A@42 V)
– WS-X6700-CFC (0.75 A@42 V)
• WS-X6724-SFP ships with WS-X6700-CFC installed unless ordered with WS-F6700-DFC3BXL or WS-F6700-DFC3B.
• WS-X6724-SFP is supported in the WS-C6503-E chassis.
• WS-X6724-SFP is not supported in the WS-C6503 and CISCO7603 chassis.
• On WS-X6724-SFP ports, STP BPDUs are not exempt from Traffic Storm Control suppression. Do not configure Traffic
Storm Control on STP-protected WS-X6724-SFP ports that interconnect network devices.
• See the “Small Form-Factor Pluggable Modules (SFPs)” section on page 42.
WS-X6816-GBIC
3.84 A@42 V 16-port Gigabit Ethernet GBIC
• dCEF256
• QoS port architecture (Rx/Tx): 1p1q4t/1p2q2t
Number of ports: 16
Number of port groups: 2
Port ranges per port group: 1–8, 9–16
With Supervisor Engine 720 12.2(33)SRA
Note
•
WS-X6816-GBIC requires one of these for use with Supervisor Engine 720:
– WS-F6K-DFC3BXL (adds 1.47 A@42 V)
– WS-F6K-DFC3B (adds 1.67 A@42 V)
• In a 13-slot chassis, WS-X6816-GBIC is supported only in slots 9 through 13 and does not power up in other slots.
Product ID
(append “=” for spares)
Power
Required Product Description
Minimum
Software Version