An Overview of Your Phone
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G User Guide 33
Understanding Out-of-Range Alerts
Your system administrator can configure your phone to send you an audible alert (beep) when you are
out of range of the wireless network. When you hear the alert, the
(no signal) icon displays on the
phone screen.
When you are out of range of the wireless network, you cannot use the phone for features requiring a
wireless network connection, such as making and receiving calls.
If your system administrator enabled the out-of-range alert, depending on the configuration, you
might hear a beep only once, or every 10, 30, or 60 seconds until you are back within range of the
wireless network.
BLF-monitored line is
idle
See Using BLF to Determine a Line State, page 63.
BLF-monitored line is
in-use
See Using BLF to Determine a Line State, page 63.
BLF-monitored line is
in Do Not Disturb state
See Using BLF to Determine a Line State, page 63.
BLF indicator is
unavailable for this line
See Using BLF to Determine a Line State, page 63.
Remote line in use A shared line is in use remotely. See Using a Shared Line,
page 60.
Call on hold You have put this call on hold. See Using Hold and Resume,
page 42.
Call forward enabled You have forwarded your primary line. See Forwarding Calls
to Another Number, page 46.
Authenticated call See Tracing Suspicious Calls, page 65.
Encrypted call See Tracing Suspicious Calls, page 65.
Idle Intercom line The intercom line is not in use. See Placing or Receiving
Intercom Calls, page 53.
One-way Intercom call The intercom line is sending or receiving one-way audio. See
Placing or Receiving Intercom Calls, page 53.
Two-way Intercom call The recipient pressed the intercom line to activate two-way
audio with the caller. See
Placing or Receiving Intercom
Calls, page 53.
Icon Line or call state Description
To Next Page
Loading...
