Cisco 7965G Guide

Cisco Unified IP Phone 7965G and 7945G Phone Guide for Cisco Unified Communications Manager 7.1(2) 53
Using a Handset, Headset, and Speakerphone
You can use your phone with these audio devices: a handset, headset, or speakerphone.
The phone is off-hook when the handset is lifted or another audio device is in use.
The phone is on-hook when the handset is in its cradle and other audio devices are not in use.
Using a Handset
If you want to... Then...
Use the handset Lift it to go off-hook; replace it to go on-hook.
The ringing line is automatically selected. Ask your system
administrator about options to always select the primary line.
Switch to the speakerphone or
headset during a call
Press or , then hang up the handset.
Adjust the volume level for a
call
Press during a call or after invoking a dial tone.
Press Save to preserve the volume level for future calls.
Using a Headset
Your phone supports four- or six-wire headset jacks for wired headsets, and also supports wireless
headsets. For information about purchasing headsets, see
Headset Support, page 6.
You can use a headset with all of the controls on your phone, including and .
However, if you use a wireless headset, refer to the wireless headset documentation for information.
If you want to... Then...
Toggle headset mode on and off Press .
Switch to a handset Lift the handset.
Adjust the volume level for a
call
Press during a call or after invoking a dial tone.
Press Save to preserve the volume level for future calls.
If you use AutoAnswer, see Using AutoAnswer with a Headset or Speakerphone, page 55.

Cisco 7965G Specifications

General

Protocol Support	SIP, SCCP
Weight	3.5 lbs (1.6 kg)
Ethernet	10/100 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE)
Expansion Module Support	Supports up to two Cisco Unified IP Phone Expansion Modules
Speakerphone	Full-duplex speakerphone
Lines	6 lines
Codecs	G.711, G.729a, iLBC