Cisco 8832 - Enable Anonymous Call Blocking from the Phone Web Page; Enable Call Waiting from the Phone Web Page; Block an Anonymous Call

Procedure
Step 1 On the phone web page, select User Login > Advanced > Voice > User.
Step 2 Under Screen, select a duration for the Back Light Timer parameter.
Enable Anonymous Call Blocking from the Phone Web Page
Procedure
Step 1 On the phone web page, select User Login > Voice > User.
Step 2 Under Supplementary Services, set Block ANC Setting to Yes.
The setting applies to all lines, except for the ones where your administrator has enabled synchronization of
Anonymous Call Rejection between the lines and the BroadSoft XSI service.
Step 3 Click Submit All Changes.
Enable Call Waiting from the Phone Web Page
Procedure
Step 1 On the phone web page, select User Login > Voice > User.
Step 2 Under Supplementary Services, set CW Setting to Yes.
The setting applies to all lines, except for the ones where your administrator has enabled synchronization of
Call Waiting between the lines and the BroadSoft XSI service.
Step 3 Click Submit All Changes.
Block an Anonymous Call
You can block an incoming call that does not have caller information for a specific line or all lines.
If your administrator has enabled synchronization of Anonymous Call Rejection between a line and a BroadSoft
XSI service, then your setting only applies to the specific line instead of all lines. Typically, the setting applies
to all the lines, except for the ones where the synchronization is enabled.
Settings
6
Settings
Enable Anonymous Call Blocking from the Phone Web Page