To Next PageTo Next Page
What to do if my Cisco 8841 displays an "Initialising Network" message constantly?
Check the connection from the handset to the router or switch to ensure it's receiving a signal. Swap out Cat 5 cables and check ports, as well as connections on all wires. Also, plug the handset into a different port that you know definitely works.
General| Resolution | 800 x 480 pixels |
|---|---|
| Audio | Wideband audio |
| Bluetooth | No |
| Ethernet | 10/100/1000 Mbps |
| PoE | IEEE 802.3af compliant |
| Connectivity | Ethernet |
| Buttons | 4 programmable line keys |
| Speakerphone | Full-duplex speakerphone |
| Headset Jack | Yes, RJ9 |
| Codecs | G.711, G.722, G.729a, iLBC |
| Power Options | PoE |
| Network Interfaces | Dual Gigabit Ethernet ports |
| Security | Secure boot, 802.1X authentication, secure credential storage |
| Dimensions | 40 mm |
| Weight | 2.5 lb (1.1 kg) |
