Cisco 8845 Firmware Migration Master Guide

© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Internal Information. Page 26 of 30
Appendix C: Bulk Provisioning (Unified CM-Based Method)
The following steps will convert multiple phones from Enterprise to MPP firmware.
Prerequisites
• Set up the DHCP option and file server for MPP.
• Upgrade the enterprise phones to firmware version 12.5 with Unified CM.
Example: sip88xx.12-5-1SR1-4
1. Upgrade the enterprise phones to the E2M migration load from the Unified FM by specifying the load name (for example,
sip88xx.TLexE2M-11-2-3C12) and load server (for example, 10.23.45.67).
2. Allow the phones to boot up with the E2M migration firmware and find DHCP option 160.
• The device requests $PSN.xml (for example http://10.23.56.67/8851-3PCC.xml
• Each phone replaces the $MAU macro with its uppercase MAC address to retrieve the device-specific license file to unable
the upgrade to the requested MPP firmware.

Cisco 8845 Specifications

General

Camera	No
Audio	Wideband audio
Speakerphone	Yes
Wi-Fi	No
Display	5-inch color display
Resolution	480 x 272 pixels
Ethernet	10/100/1000 Mbps
PoE	IEEE 802.3af/at
Protocols	SIP
Codecs	G.711, G.722, G.729a, iLBC
USB Ports	2 x USB 2.0