Cisco 8945 Administration Guide

To changeDescriptionOption
Set Admin VLAN ID Field, on page
10
Auxiliary VLAN in which the phone is a
member.
Used only if the phone does not receive an
auxiliary VLAN from the switch; otherwise
it is ignored.
Admin. VLAN ID
Set PC VLAN Field, on page 11Allows the phone to interoperate with
third-party switches that do not support a
voice VLAN. The Admin VLAN ID option
must be set before you can change this
option.
PC VLAN
Set SW Port Setup Field, on page
11
Speed and duplex of the network port. Valid
values are:
•
Auto Negotiate
•
1000 Full: 1000-BaseT/full duplex
(Supported only for Cisco Unified IP
Phone 8945.)
•
100 Half: 100-BaseT/half duplex
•
100 Full: 100-BaseT/full duplex
•
10 Half: 10-BaseT/half duplex
•
10 Full: 10-BaseT/full duplex
If the phone is connected to a switch,
configure the port on the switch to the same
speed/duplex as the phone, or configure
both to autonegotiate.
If you change the setting of this option, you
must change the PC Port Configuration
option to the same setting.
SW Port Setup
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0 (SCCP
and SIP)
7
Cisco Unified IP Phone Installation
Configure Network Settings

Cisco 8945 Specifications

General

Brand	Cisco
Model	8945
Category	IP Phone
Language	English