Cisco Aironet 1200 Series - Page 5

Contents
v
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-8370-04
Installing a 5-GHz Radio Module 5-5
Attaching the Compliance Label 5-7
CHAPTER 6 Troubleshooting Autonomous Access Points 6-1
Checking the Top Panel LEDs 6-2
Checking Basic Settings 6-4
Default IP Address Behavior 6-4
Default SSID and Radio Behavior 6-4
Enabling the Radio Interfaces 6-4
SSID 6-5
WEP Keys 6-5
Security Settings 6-5
Running the Carrier Busy Test 6-5
Running the Ping or Link Test 6-6
Resetting to the Default Configuration 6-7
Using the MODE Button 6-7
Using the Web Browser Interface 6-8
Reloading the Access Point Image 6-8
Using the MODE button 6-9
Web Browser Interface 6-10
Browser HTTP Interface 6-10
Browser TFTP Interface 6-10
Obtaining the Access Point Image File 6-11
Obtaining the TFTP Server Software 6-12
Connecting to the Access Point Locally 6-13
CHAPTER 7 Troubleshooting Lightweight Access Points 7-1
Guidelines for Using 1200 Series Lightweight Access Points 7-2
Using DHCP Option 43 7-2
Checking the Top Panel LEDs 7-3
Manually Configuring Controller Information Using the Access Point CLI 7-5
Configuring Controller Information 7-5
Clearing Manually Entered Controller Information 7-5
Manually Resetting the Access Point to Defaults 7-6
Returning the Access Point to Autonomous Mode 7-6
Using a Controller to Return the Access Point to Autonomous Mode 7-6
Using the MODE Button to Return the Access Point to Autonomous Mode 7-7
MODE Button Setting 7-7