Cisco Aironet 1200 Series - Page 64

5-8
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-8370-04
Chapter 5 Upgrading the 5-GHz Radio Module
Installing a 5-GHz Radio Module
Step 1 Check the product compliance label to identify the model number of your 1200 series access point.
Step 2 Refer to Figure 5-6 for the compliance label locations.
Step 3 Use the matrix in Table 5-1 to decide which labels to use and where to place them on the access point.
Step 4 Discard any labels that you did not use.
The 5-GHz radio module installation is now complete and radio settings are at default values. To
co
nfigure the 5-GHz radio with your wireless network settings refer to the Cisco IOS Software
Configuration Guide for Cisco Aironet Access Points.
Ta b l e 5-1 Locations for Compliance Labels
1200 Series
Model
AIR-RM21A-x-K9 or AIR-RM22A-x-K9
Radio Compliance Label
AIR-AP1210-x-K9 Product
Compliance Label
AIR-AP1220A Place over existing AIR-RM20A-x-K9
r
adio compliance label or location 3 if no
label exists.
Place over existing product compliance
label.
AIR-AP1230A
All other models Discard product compliance label.