6-10
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Chapter 6 Configuring Voice over IP
Configuring Basic VoIP
Table 6-6 VoIP Dial-Peer Configuration Commands
Command Purpose
acc-qos
Sets minimally acceptable quality of service for calls to this peer.
answer-address
Sets call destination number.
application
Sets selected application.
clid_restrict
Restricts display of caller ID.
codec
Sets codec for calls to this peer.
default
Set a command to its defaults.
destination-pattern
Sets full E.164 telephone number.
dtmf-relay
Transports DTMF digits across IP link.
exit
Exits dial-peer configuration mode.
expect-factor
Sets expectation factor for voice quality.
fax
Configures fax service.
fax-relay
Sets fax-relay options.
huntstop
Stops hunting on dial peers.
icpif
Sets calculated planning-impairment factor.
incoming
Sets incoming called number.
information-type
Sets information type for dial peer.
ip
Sets IP packet options.
max-conn
Sets maximum connections per peer; “no” sets to unlimited.
max-redirects
Sets maximum redirects for this peer.
no
Negates a command or sets its defaults.
numbering-type
Sets calling/called party numbering type.
preference
Configures preference order of the peer.
req-qos
Sets required quality of service for calls to this peer.
roaming
Sets use of roaming server.
session
Sets session [target | protocol | transport] for this peer.
settle-call
Sets use of settlement server.
shutdown
Changes admin state of this peer to down (no->up).
snmp
Modifies SNMP voice-peer parameters.
tech-prefix
Sets H.323 gateway technology prefix.
translate-outgoing
Sets translation rule.
vad
Sets use of Voice Activity Detection.
voice-class
Sets dial-peer voice-class control parameters.
To Next Page
Loading...
