3-16
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Chapter3 Basic Configuration Using the Command-Line Interface
Configuring ISDN PRI
Verify
To verify that you have configured the interfaces correctly:
• Enter the show controller t3 command and specify the slot and port numbers. Verify that the
controller is up and that you do not have excessive errors; otherwise your controller might go down
frequently. This could indicate switch problems.
AS5400# show controller t3 1/0
T3 1/0 is up.
Applique type is Channelized T3
No alarms detected.
MDL transmission is disabled
FEAC code received:No code is being received
Framing is C-BIT Parity, Line Code is B3ZS, Clock Source is Internal
Data in current interval (270 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
0 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
Total Data (last 32 15 minute intervals):
0 Line Code Violations, 0 P-bit Coding Violation,
0 C-bit Coding Violation, 0 P-bit Err Secs,
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs,
0 Unavailable Secs, 0 Line Errored Secs,
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
Table 3-3 ISDN Service-Provider PRI Switch Types
Area Keyword Switch Type
none none No switch defined
Australia primary-ts014 Australia PRI switches
Europe primary-net5 European, New Zealand, and Asia ISDN PRI
switches (covers the Euro-ISDN E-DSS1
signaling system and is European
Telecommunication Standards Institute or
ETSI-compliant)
Japan primary-ntt Japanese ISDN PRI switches
North America primary-4ess AT&T 4ESS switch type for the United States
primary-5ess AT&T 5ESS switch type for the United States
primary-dms100 NT DMS-100 switch type for the United States
primary-ni National ISDN switch type
To Next Page
Loading...
