Cisco AS5350 - Universal Access Server - Undoing a Command or Feature

1-9
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Chapter 1 Understanding Basic Hardware Architecture and CiscoIOS Software
Exploring Cisco IOS Software
Undoing a Command or Feature
If you want to undo a command you entered or disable a feature, enter the keyword no before most
commands; for example, no ip routing.
Step 7
Router(config-controller)# ds0-group 1 timeslots ?
<1-24> List of timeslots which comprise the
ds0-group
Displays the range for the timeslot
option. Specify a timeslot range of
values from 1 to 24. You can specify
timeslot ranges (for example, 1-24),
individual timeslots separated by
commas (for example 1, 3, 5), or a
combination of the two (for example 1-3,
8, 17-24). The 16th timeslot is not
specified in the command line, because it
is reserved for transmitting the channel
signaling.
Step 8
Router(config-controller)# ds0-group 1 timeslots
1-24 ?
Displays the two commands (service and
type) available for the timeslots.
service
type
Specify the type of service
Specify the type of signaling
Step 9
Router(config-controller)# ds0-group 1 timeslots
1-24 type ?
Lists supported signaling types.
e&m-fgb
e&m-fgd
e&m-immediate-start
fxs-ground-start
fxs-loop-start
sas-ground-start
sas-loop-start
E & M Type II FGB
E & M Type II FGD
E & M Immediate Start
FXS Ground Start
FXS Loop Start
SAS Ground Start
SAS Loop Start
Step 10
Router(config-controller)# ds0-group 1 timeslots
1-24 type e&m-fgb ?
dtmf DTMF tone signaling
mf MF tone signaling
service Specify the type of service
<cr>
Displays the types of channel-associated
signaling available for the e&m-fgb
type.
Step 11
Router(config-controller)# ds0-group 1 timeslots
1-24 type e&m-fgb dtmf ?
dnis DNIS addr info provisioned
service Specify the type of service
<cr>
Displays the options supported for the
DTMF tone signaling option.
Command Purpose