Cisco AS5350 - Universal Access Server - Save the Configuration File

-15
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Appendix
Save the Configuration File
Step 14 Enter yes to configure the FastEthernet0/0 interface to connect the gateway to a LAN, then respond to
the remaining questions to configure the FastEthernet port (you can also press Enter to accept the
default):
Do you want to configure FastEthernet0/0 interface? [yes]: yes
Use the 100 Base-TX (RJ-45) connector? [yes]:
Note Full duplex mode enables simultaneous data transfer between a sending and a receiving station.
Operate in full-duplex mode? [no]:
Operate at 100 Mbps speed? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [X.X.X.X]: 172.22.50.10
Subnet mask for this interface [255.255.0.0] :
Class B network is 172.22.0.0, 16 subnet bits; mask is /16
Step 15 Repeat Step 14 to configure any other FastEthernet ports, if necessary.
Step 16 Configure your serial interfaces by responding to the following prompts:
Do you want to configure Serial0/0 interface? [no]: yes
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
Assign to which interface [FastEthernet0/0]:
Step 17 Repeat Step 16 to configure any other serial interfaces, if necessary.
After you complete the configuration script, the setup script displays the configuration command script.
Step 18 Go to the next section “Save the Configuration File.”
Save the Configuration File
Step 1 Enter 0, 1, or 2 when the following prompt is displayed:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
%LINK-3-UPDOWN: Interface Ethernet0, changed state to up
%LINK-3-UPDOWN: Interface Serial0, changed state to down
%LINK-3-UPDOWN: Interface Serial1, changed state to down
<Additional messages omitted.>