Cisco AS5350 - Universal Access Server - Chapter 3 Basic Configuration Using the Command-Line Interface

2-10
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Chapter2 Verifying Basic Setup
Where to Go Next
Where to Go Next
At this point you should go to:
• Chapter 3, “Basic Configuration Using the Command-Line Interface” to commission your
Cisco AS5350 or Cisco AS5400 universal gateway.
Tip The following publications are available on the Documentation CD-ROM that shipped with your
gateway, or on the World Wide Web from the Cisco home page.
• For additional basic configuration information, refer to Cisco IOS Dial Technologies Configuration
Guide and Cisco IOS Dial Technologies Command Reference, available online at
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/index.htm. For more
advanced configuration topics, refer to the Cisco IOS software configuration guide, feature
modules, and command reference publications that pertain to your Cisco IOS software release.
• Check Configuring Selected 12.1 Cisco IOS Software Features, available online at
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_serv/as5400/index.htm
• For troubleshooting information, refer to the System Error Messages and Debug Command
Reference publications.