Cisco AS5350 - Universal Access Server - Appendix; Comprehensive Configuration Examples; CT3 CAS;ISDN with RADIUS

-1
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
APPENDIX C
Comprehensive Configuration Examples
Note The information herein applies to the Cisco AS5350, Cisco AS5400, and Cisco AS5400HPX universal
gateways. Note that the latter requires use of Cisco IOS release 12.2(2)XB or later.
This appendix includes sample outputs of the show config command after completing the procedures in
“Chapter 2, “Verifying Basic Setup”” and configuring various advanced features.
The following examples are useful references for you only if you are experienced with the Cisco IOS
software:
• CT3 CAS/ISDN with RADIUS, page C-1
• CT3 CAS/ISDN Without RADIUS, page C-11
• CT3 Without Resource Pooling, page C-20
• CT3 CAS with Resource Pooling, page C-26
• Two 8 T1/PRI ISDN with Modems, page C-32
• Two 8 E1/PRI ISDN with Modems, page C-44
• Two 8 T1/PRI CAS with Modems, page C-49
• Two 8 T1/PRI CAS with RADIUS (AAA) and Resource Pooling, page C-54
• Two 8 T1/PRI ISDN with RADIUS (AAA) and Resource Pooling, page C-59
• Two 8 E1/PRI ISDN with RADIUS (AAA) and Resource Pooling, page C-71
• CT3 with Resource Pooling, AAA, and Modem, page C-75
CT3 CAS/ISDN with RADIUS
AS5400# show config
Building configuration ...
Current configuration:
!
version 12.1
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
service internal