-6
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Appendix
Getting Started
Step 19 Enter the tone signaling type.
The following tone signaling types are available:
dtmf | mf
Enter the tone signal type [dtmf]:
Step 20 Enter yes to configure digital number identification service (DNIS).
Do you want to provision DNIS address information? [yes]: yes
Step 21 Repeat Step 15 to Step 20 to configure the remaining controllers.
Step 22 Enter yes to configure the FastEthernet0/0 interface to connect the gateway to a LAN, then respond to
the remaining questions to configure the FastEthernet port.
Do you want to configure FastEthernet0/0 interface? [yes]: yes
Use the 100 Base-TX (RJ-45) connector? [yes]:
Note Full duplex mode enables simultaneous data transfer between a sending and a receiving station.
Operate in full-duplex mode? [no]:
Operate at 100 Mbps speed? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [X.X.X.X]: 172.22.50.10
Subnet mask for this interface [255.255.0.0] :
Class B network is 172.22.0.0, 16 subnet bits; mask is /16
Step 23 Repeat Step 22 to configure any other FastEthernet ports, if necessary.
Step 24 Configure your serial interfaces by responding to the following prompts:
Do you want to configure Serial0/0 interface? [no]: yes
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
Assign to which interface [FastEthernet0/0]:
Step 25 Repeat Step 24 to configure any other serial interfaces, if necessary.
After you complete the configuration script, the setup script displays the configuration command script.
Step 26 Go to the “Save the Configuration File” section on page A-15.
To Next Page
Loading...
