3-38
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Chapter3 Basic Configuration Using the Command-Line Interface
Testing Asynchronous Shell Connections
Step 3 Dial the PRI telephone number assigned to the gateway (in this example, the number is 5554100). After
the modem successfully connects, a connect message appears.
atdt 5554100
CONNECT 33600/REL - LAPM
Note Many modems support the a/ command, which recalls the last AT command. The ath command
hangs up a modem call. The atdl command dials the last telephone number.
Step 4 Log in to the EXEC session on the gateway (from the client PC):
This is a secured device.
Unauthorized use is prohibited by law.
User Access Verification
Username: Harry
Password:
AS5400>
Step 5 Identify the line where the call landed. The following example shows that line TTY 216 accepted the
call. The call has been up and active for 30 seconds.
AS5400# show caller
Active Idle
Line User Service Time Time
con 0 admin TTY 00:39:09 00:00:00
tty 216 Harry TTY 00:00:30 00:00:07
AS5400# show caller user Harry
User: Harry, line tty 216, service TTY
Active time 00:00:42, Idle time 00:00:19
Timeouts: Absolute Idle Idle
Session Exec
Limits: - - 00:10:00
Disconnect in: - - 00:09:40
TTY: Line 1/00
DS0: (slot/unit/channel)=2/0/18
Line: Baud rate (TX/RX) is 115200/115200, no parity, 1 stopbits, 8 databits
Status: Ready, Active, No Exit Banner
Capabilities: No Flush-at-Activation, Hardware Flowcontrol In
Hardware Flowcontrol Out, Modem Callout, Modem RI is CD
Integrated Modem
Modem State: Ready
Note The show caller command is added to the Cisco IOS software in Cisco IOS Release 11.3 AA
and Release 12.0 T. If your software release does not support this command, use the show user
command.
To Next Page
Loading...
