Cisco AS5350 - Universal Access Server - Page 94

4-8
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Chapter 4 Continuing Configuration Using the Command-Line Interface
Configuring E1 R2 Signaling
Step 7
AS5350(config-ctrl-cas)# answer-signal
group-b 6
[or]
AS5350(config-ctrl-cas)# default
answer-signal group-b 6
[or]
AS5350(config-ctrl-cas)# no answer-signal
group-b 6
controller E1 0
clock source line primary
ds0-group 0 timeslots 1-15,17-31 type
r2-analog
r2-compelled
cas-custom 0
country singapore use-defaults
category 2 <--- default category for
singapore
answer-signal group-b 6 <--- default
bxfree
for singapore
AS5350(config-ctrl-cas)# exit
AS5350(config)#
Sets the cas custom command answer-signal to
group-b to 6.
Cas custom commands include caller-digits,
category, country, unused-abcd, invert-abcd,
metering, ka, kd, dnis-digits, answer-signal, and
nc-congestion
Sets answer-signal group-b to the default ITU
value.
Resets answer-signal group-b 6 to the default
value.
Note The parameters you do not set are
automatically set to the ITU default by the
gateway.
After you configure a country with default
settings, the gateway displays a write term, similar
to the one displayed here.
Exits cas-custom mode and returns to global
configuration mode.
Step 8
AS5350(config)# spe country {country |
e1-default}
Set the SPE country code or use the E1 default
(A-Law).
Note The gateway must be in idle state (no calls
are active) to execute the SPE country
command
Note On the Cisco AS5350 and Cisco AS5400,
DS-0 companding law selection is
configured for the entire system rather
than on individual voice ports.
Step 9
AS5350(config)# voice-port
slot/controller-number:DS0 group-number
AS5350(config-voiceport)#
Enter voice port mode for the port you want to
configure.
Step 10
AS5350(config-voiceport)# cptone
contry-code
Enter the two-digit country code to configure the
regional ring tone.
Step 11
AS5350(config-voiceport)# Ctrl-Z
AS5350#
Return to enable mode.
Command Purpose