Cisco ASA 5585-X Cli Configuration Guide

1-13
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the Identity Firewall
Task Flow for Configuring the Identity Firewall
What to Do Next
Configure access rules for the Identity Firewall. See Configuring Identity-Based Security Policy,
page 1-18.
Configuring Identity Options
Perform this procedure to add or edit the Identity Firewall feature; select the Enable check box to enable
the feature. By default, the Identity Firewall feature is disabled.
Prerequisites
Before configuring the identify options for the Identity Firewall, you must you must meet the
prerequisites for the AD Agent and Microsoft Active Directory. See Prerequisites, page 1-8 the
requirements for the AD Agent and Microsoft Active Directory installation.
To configure the Identity Options for the Identity Firewall, perform the following steps:

Cisco ASA 5585-X Specifications

General

Firewall Throughput	up to 20 Gbps
Maximum VPN Peers	10, 000
IPS Throughput	up to 10 Gbps
Maximum Concurrent Connections	10, 000, 000
Security Contexts	250
Interfaces	8 x 10 Gigabit Ethernet
Connections Per Second	350, 000
Power Supply	Dual, hot-swappable