Cisco ASR 1002 User Manual

Page 42 of 72
 The ‘discard’ option is accomplished using access lists with deny entries, which are
applied to interfaces within access-groups. Guidance for configuration of IOS
Information Flow Policies is located in the [23] Under “IP Access List Overview”
 The ‘bypassing’ option is accomplished using access lists with deny entries, which
are applied to interfaces within crypto maps for IPsec. Guidance for configuration of
entries for IPsec is in [10]
 The ‘protecting’ option is accomplished using access lists with permit entries, which
are applied to interfaces within crypto maps for IPsec VPN.
The criteria used in matching traffic in all of these access lists includes the source and destination
address, and optionally the Layer 4 protocol and port.
The TOE enforces information flow policies on network packets that are receive by TOE
interfaces and leave the TOE through other TOE interfaces. When network packets are received
on a TOE interface, the TOE verifies whether the network traffic is allowed or not and performs
one of the following actions, pass/not pass information, as well as optional logging.
4.6.6 IPsec Session Interuption/Recovery
If an IPsec session with a peer is unexpectedly interrupted, the connection will be broken. In
these cases, no administrative interaction is required. The IPsec session will be reestablished (a
new SA set up) once the peer is back online.

Cisco ASR 1002 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.3
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
DHCP client	-
Supported network protocols	BGP, GRE, OSPF, DVMRP, EIGRP, IS-IS, IGMPv3, PIM-SM, PIM-SSM
Ethernet LAN (RJ-45) ports	4
Security algorithms	SSH
VPN tunnels quantity	8000
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	4096 MB
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	560 W
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Product color	Gray
Rack capacity	2U

Weight and Dimensions

Depth	461 mm
Width	437.4 mm
Height	89 mm
Weight	- g