Cisco ASR 1004 Replacing

6. Wrap two packaging straps tightly around the top and bottom of the package to hold the outside carton
and the bottom pallet.
DETAILED STEPS
Step 1 Place the bottom packing material section inside the bottom of the shipping container.
Step 2 Use at least two people to place the Cisco ASR 1000 Series Router inside the container. Be sure that the chassis is
positioned correctly before you lower it inside the container.
Step 3 Place the top packing material over the top of the Cisco ASR 1000 Series Router.
Step 4 Place both accessory boxes inside the cutouts in the top section of the packing material.
Step 5 Fold the outside carton down over the top of the accessory boxes and seal with packing tape.
Step 6 Wrap two packaging straps tightly around the top and bottom of the package to hold the outside carton and the bottom
pallet.
Do not use tape to hold the outside carton to the bottom pallet. Packaging straps must be used.
Caution
What to do next
This completes the procedure for repacking the shipping container.
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
120
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Repacking the Router

Cisco ASR 1004 Specifications

General

Product Type	Router
Form Factor	Rack-mountable
Rack Height	2U
Forwarding Capacity	Up to 20 Gbps
Total Number of Ports	Varies by configuration
Number of Total Expansion Slots	4
Product Series	ASR 1000
Model	ASR 1004
Forwarding Performance	Up to 20 Gbps
Operating System	Cisco IOS XE
Power Supply	Dual
Route Processor	ASR 1000 Series Route Processor
Network Interface Modules	SFP, SFP+, Gigabit Ethernet, 10 Gigabit Ethernet
Interfaces/Ports	Varies by configuration
Expansion Slot Type	SPA
Throughput	20 Gbps
Redundancy	Power supply, Route Processor
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, SFP, SFP+
Storage	Up to 64 GB Flash