Cisco ASR 1004 Install Guide

CHAPTER
7-1
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-09
7
Cisco ASR 1004 Router Overview and Installation
This chapter describes the Cisco ASR 1004 Router and the procedures for installing the Cisco ASR 1004
Router on an equipment shelf or tabletop or in equipment racks. It also describes how to connect
interface and power cables.
This chapter contains the following sections:
• Cisco ASR 1004 Router Description, page 7-2
• Installation Methods, page 7-5
• General Rack Installation Guidelines, page 7-6
• Guidelines for an Equipment Shelf or Tabletop Installation, page 7-7
• Equipment Shelf or Tabletop Installation, page 7-7
• Rack-Mounting the Cisco ASR 1004 Router, page 7-9
• Attaching the Chassis Rack-Mount Brackets, page 7-10
• Installing the Cisco ASR 1004 Router in a Rack, page 7-13
• Attaching a Chassis Ground Connection, page 7-17
• Attaching the Cable-Management Bracket, page 7-19
• Connecting the Shared Port Adapter Cables, page 7-21
• Connecting the Console and Auxiliary Port Cables, page 7-21
• Connecting Power to Cisco ASR 1004 Router, page 7-22
• Connecting a Terminal to the Cisco ASR Series 1000 Route Processor Console Port, page 7-29
• Connecting the Network Management and Signal System Cables, page 7-30
• Auxiliary Connection, page 7-31
Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
Warning Before you install, operate, or service the system, read the Regulatory Compliance and Safety
Information for Cisco ASR 1000 Series Aggregation Services Routers publication. This document
provides important safety information you should know before working with the system. Statement 200

Cisco ASR 1004 Specifications

General

Product Type	Router
Form Factor	Rack-mountable
Rack Height	2U
Forwarding Capacity	Up to 20 Gbps
Total Number of Ports	Varies by configuration
Number of Total Expansion Slots	4
Product Series	ASR 1000
Model	ASR 1004
Forwarding Performance	Up to 20 Gbps
Operating System	Cisco IOS XE
Power Supply	Dual
Route Processor	ASR 1000 Series Route Processor
Network Interface Modules	SFP, SFP+, Gigabit Ethernet, 10 Gigabit Ethernet
Interfaces/Ports	Varies by configuration
Expansion Slot Type	SPA
Throughput	20 Gbps
Redundancy	Power supply, Route Processor
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, SFP, SFP+
Storage	Up to 64 GB Flash