Cisco ASR 9000v User Manual

Procedure
Step 1 Remove any strapping on the outside of the crate.
Step 2 Remove the crate cap door. Disengage the twist locks located along the bottom first. Then, disengage the twist
locks located along the sides, working your way up from the bottom to the top. Refer to the right and middle
figures in Figure 73: Unpacking the Cisco ASR 9922 Router from the Shipping Container, on page 69.
Step 3 Remove the crate cap. Disengage the twist locks located around the bottom of the crate cap (Figure 73:
Unpacking the Cisco ASR 9922 Router from the Shipping Container, on page 69).
Two people are required to evenly slide the crate cap back off of the plastic pallet base.
Note
Step 4 Remove the foam packaging material from the top of the router.
Figure 73: Unpacking the Cisco ASR 9922 Router from the Shipping Container
Step 5 Using a 5/16” wrench or ratchet, remove the four attachment bolts and cross-brace from the shipping rack
(see the figure below).
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
69
Unpacking and Installing the Chassis
Unpacking the Cisco ASR 9922 Router

Cisco ASR 9000v Specifications

General

Chassis Type	Virtual
Operating System	Cisco IOS XR
Form Factor	Virtual Appliance
Type	Virtual Router
License Required	Yes
Supported Platforms	VMware ESXi, KVM, Microsoft Hyper-V
Interfaces	Virtual Ethernet
High Availability	Yes
Management	CLI, NETCONF
Protocols	BGP, OSPF, IS-IS, MPLS, IPv4, IPv6
Product Family	Cisco ASR 9000 Series
Encryption Support	Yes