Cisco C1121-4P - Page 56

96 pages

To Next Page

To Previous Page

Figure 50: Power Cable for C111x

Power Cable1.

Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router

Install and Connect the Router

Connect Power Cable

Main Page

Table of Contents3
Overview of Cisco 1000 Series Integrated Services Routers7
About Cisco 1000 Series Integrated Service Routers7
Chassis Views10
LED Indicators19
Reset Button26
Power Supply26
Slots and Interfaces27
About Slots, Subslots, and Port Numbering27
Specifications of Cisco 1000 Series Integrated Services Routers27
Periodic Inspection and Cleaning27
Prepare for Router Installation29
Safety Recommendations29
Safety with Electricity30
Prevent Electrostatic Discharge Damage30
General Site Requirements30
Site Selection Guidelines31
Rack Requirements31
Safety Recommendations32
Power Guidelines and Requirements32
Network Cabling Specifications33
Console Port Considerations33
Eia/Tia-23233
USB Serial Console34
Console Port Considerations34
Prepare for Router Installation35
Ethernet Connections35
Required Tools and Equipment for Installation and Maintenance35
Install and Connect the Router37
Unpack the Router37
Set up Router on Desktop, Rack, or Wall37
Rack Mount38
Attach the Brackets for C111X38
Attach the Rack Mounting Brackets for C112X39
Mount the Router40
Mount the Router under a Desk or a Shelf41
Mount Router Using DIN Rail Brackets42
Attach Din-Rail Brackets on C112X43
Wall Mount the Router44
Wall Mount Using Key-Hole Slots44
Wall Mount Using DIN Rail Brackets51
Chassis Grounding53
Connect Power Cable55
Connect the Router to a Console57
Connect to the Serial Port with Microsoft Windows59
Connect to the Console Port with Mac os X60
Connect to the Console Port with Linux60
Connect WAN and LAN Interfaces61
Ports and Cabling61
Connection Procedures and Precautions62
Configure the Router at Startup62
Install and Upgrade Internal Modules and Field Replaceable Units63
Replace the Chassis Covers for C111X and C1111X63
Remove the Cover64
Replace the Cover65
External Modules66
Locate External Slots for Modules66
Install and Remove Small Form Pluggable Modules67
Install Small Form Pluggable Module67
Remove Small Factor Pluggable Module67
Install a Pluggable Interface Module68
Install a Pluggable Interface Module on a C1101-4P68
Configuring a Pluggable Interface Module74
RF Band Mapping for Antenna Ports (for P-5GS6-GL Only)76
LED Behaviors77
Attaching the Antennas78
Install a Micro-SIM Card into a USB LTE Dongle80
Antenna Mounting Instructions82
Rack Mount of the Antenna82
Wall Mount of the Antenna84
Ceiling Mount of the Antenna86
Installing a SIM Card on C111X, C1109-2PX, C1109-4P88
ROM Monitor Overview91
Supplier Declaration of Conformity93

Cisco C1121-4P - Page 56

Table of Contents

Related product manuals