Cisco C9200L-24P-4X User Manual

APPENDIX B
Switch LEDs
• LEDs, on page 75
• Console LED, on page 75
• System LED, on page 76
• MASTER LED, on page 76
• STACK LED, on page 77
• PoE LED, on page 78
• Port LEDs and Modes, on page 78
• Beacon LED, on page 80
• RJ-45 Console Port LED, on page 81
• Fan LED, on page 81
• Uplink Port LEDs, on page 81
LEDs
You can use the switch LEDs to monitor switch activity and its performance.
Figure 46: Switch Front Panel LEDs
Console LED
The console LED indicates whether the USB console port or the bluetooth console is enabled.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
75

Cisco C9200L-24P-4X Specifications

General

Model	C9200L-24P-4X
Device Type	Switch
Enclosure Type	Rack-mountable
Ports	24 x 10/100/1000 (PoE+)
Switching Capacity	128 Gbps
Forwarding Rate	95.23 Mpps
PoE Budget	370W
Layer	Layer 3
Stacking Bandwidth	80 Gbps
RAM	4 GB
Flash Memory	4 GB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Uplink Interfaces	4 x 10 Gigabit Ethernet
MAC Address Table Size	16000 entries
Routing Protocol	OSPF, BGP, EIGRP, RIP
Remote Management Protocol	SNMP, CLI, HTTP, HTTPS, SSH
Features	Energy Efficient Ethernet, DHCP snooping, QoS, VLAN support, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3af, IEEE 802.3at, IEEE 802.1x
Operating Temperature	0 to 45 °C
Operating Humidity	5% to 90% (non-condensing)