Cisco C9200L-24P-4X User Manual

Figure 22: Network Module Serial Number Location
Installing and Removing SFP Modules
Installing SFP/SFP+ Modules
Before you begin
See the switch release notes on Cisco.com for the list of supported SFP and SFP+ modules. Use only supported
SFP/SFP+ modules on the switch. For the latest information about supported SFP and SFP+ modules, refer
to the Cisco Transceiver Modules Compatibility Information.
For information about installing, removing, cabling, and troubleshooting SFP/SFP+ modules, see the module
documentation that shipped with your device.
Class 1 laser product. Statement 1008
Warning
• Do not remove the dust plugs from the SFP/SFP+ modules or the rubber caps from the fiber-optic cable
until you are ready to connect the cable. The plugs and caps protect the module ports and cables from
contamination and ambient light.
• Removing and installing an SFP/SFP+ module can shorten its useful life. Do not remove and insert any
SFP/SFP+ module more often than is necessary.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
35
Installing a Network Module
Installing and Removing SFP Modules

Cisco C9200L-24P-4X Specifications

General

Model	C9200L-24P-4X
Device Type	Switch
Enclosure Type	Rack-mountable
Ports	24 x 10/100/1000 (PoE+)
Switching Capacity	128 Gbps
Forwarding Rate	95.23 Mpps
PoE Budget	370W
Layer	Layer 3
Stacking Bandwidth	80 Gbps
RAM	4 GB
Flash Memory	4 GB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Uplink Interfaces	4 x 10 Gigabit Ethernet
MAC Address Table Size	16000 entries
Routing Protocol	OSPF, BGP, EIGRP, RIP
Remote Management Protocol	SNMP, CLI, HTTP, HTTPS, SSH
Features	Energy Efficient Ethernet, DHCP snooping, QoS, VLAN support, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3af, IEEE 802.3at, IEEE 802.1x
Operating Temperature	0 to 45 °C
Operating Humidity	5% to 90% (non-condensing)