Cisco C9200L-24P-4X User Manual

Redundant Distribution
Switch (Port Channel
Peer and Downlink)
Single Distribution
Switch (Single Port
Channel Downlink)
Single Distribution
Switch (Single Downlink)
Setting
Source Destination IPSource Destination IPSource Destination IPPort Channel Load
Balance
Version 2Version 2Version 2SSH
EnabledEnabledEnabledSCP
EnabledEnabledEnabledVTY Access to Switch
EnabledEnabledEnabledService Timestamp
The following VLANs are
created:
• Default VLAN
• Data VLAN
• Voice VLAN
• Management VLAN
The following VLANs are
created:
• Default VLAN
• Data VLAN
• Voice VLAN
• Management VLAN
The following VLANs are
created:
• Default VLAN
• Data VLAN
• Voice VLAN
• Management VLAN
VLAN
Layer 3 settings
configured on the
management port, based
on Quick Setup
Layer 3 settings
configured on the
management port, based
on Quick Setup
Layer 3 settings
configured on the
management port, based
on Quick Setup
Management Interface
QoS Policy for
Distribution defined
QoS Policy for
Distribution defined
QoS Policy for
Distribution defined
QoS Policy
Selected uplink ports
connect to other
distribution or core
switches
Selected uplink ports
connect to other
distribution or core
switches
Selected uplink ports
connect to other
distribution or core
switches
Uplink Interfaces
Downlink connections to
access switches
configured in Trunk mode
Downlink connections to
access switches
configured in Trunk mode
Downlink connections to
access switches
configured in Trunk mode
Downlink Interfaces
Port-channel to core or
distribution created
Port-channel to core or
access created
Port-channel to core
created
Port-channel
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
57
Configuring the Switch
Configuring Your Device Based on a Site Profile

Cisco C9200L-24P-4X Specifications

General

Model	C9200L-24P-4X
Device Type	Switch
Enclosure Type	Rack-mountable
Ports	24 x 10/100/1000 (PoE+)
Switching Capacity	128 Gbps
Forwarding Rate	95.23 Mpps
PoE Budget	370W
Layer	Layer 3
Stacking Bandwidth	80 Gbps
RAM	4 GB
Flash Memory	4 GB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Uplink Interfaces	4 x 10 Gigabit Ethernet
MAC Address Table Size	16000 entries
Routing Protocol	OSPF, BGP, EIGRP, RIP
Remote Management Protocol	SNMP, CLI, HTTP, HTTPS, SSH
Features	Energy Efficient Ethernet, DHCP snooping, QoS, VLAN support, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3af, IEEE 802.3at, IEEE 802.1x
Operating Temperature	0 to 45 °C
Operating Humidity	5% to 90% (non-condensing)